Lab High Temperature Steamer - TNG1075

The TNG1075 Lab High Temperature Steamer is designed to provide controlled thermal treatment for textile and chemical processing. It operates using electric heating for drying and curing within a temperature range of 20 ℃ to 220 ℃. For steaming, it generates saturated steam at 102±2 ℃ and can also perform high-temperature steaming between 100 ℃ and 220 ℃. The steamer is suitable for a variety of materials including dyed fabrics, chemical-treated textiles, and other materials requiring thermal processing. It supports standards such as ISO 105:2010 and ISO 105:2013 for colorfastness testing. The unit has dimensions of 690 x 1500 x 1090 mm (L x W x H). The TNG1075 is commonly used in laboratories, research institutes, and textile finishing plants for standardized testing procedures.

Lab High Temperature Steamer, the same looking as the floor type dryer, but equipped with a steam generator, thus this steamer can be widely used for drying, curing, and steaming, for the use of a wide range of the dyestuff and chemical industry, finishing plants, research institutes, and general textile industry.

• Temperature range：
• Electric heating for drying, curing 20 ℃ ~ 220℃
• Steaming with saturated steam 102±2℃
• High Temperature Steaming at 100 ~ 220 ℃
• working time is presentable for 1 ~ 999 s, automatically moving in & out, and alarms
• With the special design of a retractable pin frame, the tension of test fabric samples can be adjusted in both warp and weft direction, and the maximum stretch rate is up to 30%
• Max sample size 350 x 400mm (effective dimension 300 × 350mm)
• Suitable for the discontinuous operation in conjunction with Lab Padder
• Optional Accessories Steamer 55kg
• 690 x 1500 x 1090 mm (L x W x H)

Test procedure Before starting the equipment, we must check whether the power grounding wire is grounded in a reasonable way, whether it is easy to turn on the specially designed miniature circuit breaker, and whether the holder rests in the back position, etc. Turn on the power switch knob and then open the steam valve. The volume of the fume hood over the steam should not allow the steam to go out of it. Set the required working temperature. Set the holding time according to the tested cloth drying time, setting time, and steam time. Open the heating knob, and then open the steam valve. After reaching the required temperature, it will be automatically the heat preserved. Put the needle board frame with good cloth into the bracket, press the feed button, start the automatic work process, time is up, automatically quit and call the bell. Needle board next batch drying, steam.